Headphone Stands and Holders

Headphones in their place, not on the desk

Full-size headphones on a desk take up space, tangle with cables and fall off. On a stand they’re always to hand, and the headband isn’t pressed into the cushion the way a narrow hook does. We designed three holders for different desks: for one pair, for two and under the desk.

A saddle shaped like the headband

The top of the Arch is a curve with an 80 mm radius and 50 mm wide, close to the bend of most headbands. The weight is spread along the whole cushion instead of one point, so the foam doesn’t get squashed over time. The 240 mm height leaves room for large ear cups, and the 152 × 100 mm base keeps the stand from tipping when you lift the headphones off with one hand.

Double and under-desk

The double stand holds two pairs at the ends of a 220 mm bar: the headphones hang across the bar with the cups in front and behind, so the pairs don’t touch and the lips at the ends keep them from sliding off. Handy for two players or for gaming and work headphones.

The under-desk holder is the smallest: it screws to the underside of the desk with two screws, and the headphones hang under the edge. We recommend PETG for it: it handles constant load better.

How we print them

We print the Arch and the double stand upright, with thin supports under the curve — we remove them after printing and clean up the spots. The layers run along the upright, so it carries the headphones without bending. Any colour you like — to match your headphones or your desk.