Starlink Mini mount for a pipe, wall or window

Holds the dish by its body

The cradle is the same for every version: four arms with cups at the corners of the dish. The lip of each cup reaches 5 mm onto the face of the dish and its 45° bevel presses the dish against the arm, so case tolerances are taken up by the arms sliding in their slots. The kickstand comes off just as it does for official mounts, and the cable plug sits in a window in the hub — the cable runs down between the lower arms.

Tilt held by teeth, not friction

The tilt is locked by a 36-tooth rosette — 10° steps. Teeth do the holding, not friction, so even when the plastic settles a little in the heat the dish will not drift. Azimuth is smooth: the head’s shank turns in its socket, a collar clamps it with a screw, and the screw sits in a groove — the head cannot fall out even if the collar loosens. Everything tightens by hand, no spanner needed.

Designed for wind

It is designed for 25 m/s wind (90 km/h): that is about 35 N on the dish, and every part has a safety margin of three times or more. Clearances were checked in the model for every version, in positions from horizontal to vertical. We have not calculated for winds above 25 m/s or for icing.

Which version to choose

• Balcony, railing, mast — “Pipe or railing”: no drilling, the jaws tighten without a spanner.
• Facade or wall under the roof — “Wall”. Wall plugs do not hold in hollow brick, aerated block or insulation: those need a chemical anchor.
• A window without drilling the wall — “Window frame”, only if the frame has steel reinforcement. Drilling the frame may affect the window warranty.
• The cheapest mast option — “Budget”.
• Flat roof, terrace, yard — “Ballast stand”: three paving slabs or 7 kg sandbags, no holes at all.
• For installers — the “Adapter” for your brackets, in batches from 10 sets.

Why light-coloured plastic

We print in PETG in light colours only — white or light grey. Dark plastic reaches 60–70 °C in the summer sun and starts to creep under load, so we do not make black mounts for outdoor use. PETG without a UV stabiliser yellows on the surface over a few seasons: check the mount once a year, and we can reprint any part at low cost. Retighten the knobs after the first week of hot weather.

The mount is our own design, not an official Starlink accessory.